Ashly GQX-3102 Manuel d'utilisateur Page 9

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 12
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 8
Operator Manual – GQX Series Equalizers Page - 9
All Rights Reserved
Troubleshooting
Situation Action
No Audio Output Check AC power - is the power LED on?
Check in/out connections - are they reversed?
Are you sure you have an input signal?
EQ Controls Do Nothing Is the master EQ switch in?
The lowest and highest frequency sliders may be beyond the range of the program material
or speakers and may produce little, or no audible effect.
Peak Light Flashes or
Stays On All the Time
If the peak light flashes, the signal level to the equalizer is too high. Turn down the gain. If it
is on all the time, disconnect the input and output cables. If it is still on, the unit must be
returned for service.
Distorted Sound This will only be caused by too much signal, which will show on the Clip LED. If the LED is
not flashing, there is an overload somewhere else in the signal path. Adjust the relative gain
of each component in your chain to keep everything at a comfortable level.
Excessive Hum or Noise Hum will usually be caused by a ground loop between components. Try using the suggested
balanced input and output hook-ups if the other pieces of equipment used in conjunction with
your equalizer have balanced inputs and outputs. Noise (excessive hiss) can be caused by
insufficient drive signal. Make sure you are sending a nominal 0 dBu line level signal to the
equalizer. Most noise problems occur because gain is applied to audio signals too late in the
chain. For best performance, apply gain to individual source signals as early as possible, like
at the mixer input section. As gain increases, it also boosts the noise content of that signal.
Any cumulative noise built up in a mixed signal will only be increased by using an equalizer
as a gain device, so make every attempt to operate the equalizer with as little gain as
possible.
Note: Unshielded cables, improperly wired connections, and cable with broken strands
(shorts, etc.) are the most common problems. Make sure you use good quality cable with
connectors soldered firmly on the correct pin. When in doubt, get in touch with your Ashly
dealer.
Dimensions
Inches (Millimeters)
Safety Instructions – 3
Introduction - 4
GQX Equalizers – 5
Connectors & Cables – 5
Physical Description - 6
Installation – 7
Typical Applications - 8
Troubleshooting - 9
Dimensions - 9
Specifications - 10
Warranty - 11
Vue de la page 8
1 2 3 4 5 6 7 8 9 10 11 12

Commentaires sur ces manuels

Pas de commentaire